
The following only applies if you selected anything other 
than the default directory during installation.

Installation Issues

If another directory was selected rather than the default during 
installation of the Geocalc software, three minor modifications 
must be made for the software to function properly:

WINDOWS 95

- Locate the directory (Where you installed NBGeocalc), in 
  Windows Explorer, and select the "bin" sub-directory within 
  that directory.

- In the "bin" directory notice these files: "run1.pif", 
  "run2.pif" and "run3.pif" and follow the instructions below 
  for each of these three files.

- Right-click the file and select properties

- Select the shortcut tab and note the paths in the "Target" 
  and "Start in" textboxes.

- Replace the "NBGeocal" and drive in these paths with the 
  name of the directory and appropriate drive selected during 
  the installation and apply the changes. 
  (eg. "C:\NBGeocal\bin\run1.bat" changed to "N:\NewDir\bin\run1.bat")

- Repeat the above steps for both the "run2.pif" and "run3.pif" files.
